POLI-FLEX® Carbon Flex Film
Flex film in carbon look
Product number:
POLI-FLEX CARBON
Product information
POLI-FLEX® Carbon Flex Film
The POLI-FLEX CARBON flex film has a fashionable carbon design and is available in four colours. The surface of the POLI-FLEX CARBON flex film is slightly embossed.
Instructions
The following information is intended as a guide and may vary due to tolerances (material properties, blade wear, etc.). A test cut is required at each roll change and wash tests are recommended.
Pre-press at full press temperature for 2-3 seconds and wash inside out at least 24 hours after pressing.
| Mirror subject | Yes |
|---|---|
| Pressing temperature | 160 °C |
| Pressing time | 15 seconds |
| Contact pressure | Medium, 2,5 - 3,5 Bar |
| Pull off the backing material | Warm |
| Washable up to | 80 °C, no softener, do not tumble dry |
| Knife / Tool | 45° | Cricut: Premium Fine Point | Cameo: Autoblade | Juliet: 45° |
| Knife pressure | 80 g | Cricut: - | Cameo: 6 | Juliet: 5-10 |
| Preset | Cricut: Heat Transfer (Non-Cricut) | Cameo: Heat Transfer Smooth |
Always carry out application tests on the original material.