POLI-FLEX® TURBO® Flex Film
Fast application at low temperature
Product information
POLI-FLEX® TURBO® Flex Film
POLI-TAPE® TURBO® flex film is a high-quality PU flex film with a particularly short pressing time and is suitable for transfer to cotton, polyester and many blended fabrics, e.g. polyester/cotton.
If the textiles only allow a short pressing time or if work has to be done quickly, POLI-FLEX® TURBO® flex film is the right choice for many sensitive materials.
Please note! TURBO® flex film is not suitable for polyester fabrics which have been dyed with sublimation pigments. For particularly smooth or non-absorbent textiles, reduce the application pressure if necessary.
Instructions
The following information is intended as a guide and may vary due to tolerances (material properties, blade wear, etc.). A test cut is required at each roll change and wash tests are recommended.
Pre-press at full press temperature for 2-3 seconds and wash inside out at least 24 hours after pressing.
| Mirror subject | Yes |
|---|---|
| Pressing temperature | 130 °C | 150 °C | 160 °C |
| Pressing time | 5 seconds | 4 seconds | 3 seconds |
| Contact pressure | Medium, 2,5 - 3,5 Bar |
| Pull off the backing material | Hot |
| Washable up to | 60 °C, no softener, do not tumble dry |
| Knife / Tool | 45° | Cricut: Premium Fine Point | Cameo: Autoblade | Juliet: 45° |
| Knife pressure | 80 g | Cricut: - | Cameo: 6 | Juliet: 5-10 |
| Preset | Cricut: Heat Transfer (Non-Cricut) | Cameo: Heat Transfer Smooth |
| Notice | For neon colours, peel off the backing lukewarm / except for metallic, bright and neon colours, the series can be pressed on top of each other. |
Always carry out application tests on the original material.