Siser® Sublithin™ Matt
Solvent flex with blockout layer
Product number:
SUBLITHIN
Product information
Siser® Sublithin™ Matt LT
Siser® Sublithin™ Matt LT is a printable solvent flex film with sublimation blockout layer.
It is a matt polyurethane flex film with higher opacity and approx. 110 µ material thickness.
The film adheres to various sublimated polyester textiles and also offers excellent ink adhesion.
Instructions
The following information is intended as a guide and may vary due to tolerances (material properties, blade wear, etc.). A test cut is required at each roll change and wash tests are recommended.
Pre-press at full press temperature for 2-3 seconds and wash inside out at least 24 hours after pressing.
| Mirror subject | No |
|---|---|
| Pressing temperature | 135 °C |
| Pressing time | 15 seconds |
| Contact pressure | Medium, 2,5 Bar |
| Pull off the backing material | Warm, we recommend Siser T.T.D. Advanced |
| Washable up to | 40 °C, no softener, do not tumble dry |
| Knife / Tool | 45° | Cricut: Premium Fine Point | Cameo: Autoblade | Juliet: 45° |
| Knife pressure | 80 g | Cricut: - | Cameo: 6 | Juliet: 5-10 |
| Preset | Cricut: Heat Transfer (Non-Cricut) | Cameo: Heat Transfer Smooth |
| Notice | Ink-compatability: ECO-SOL MAX | ECO-SOL MAX 3 | TrueVIS | TrueVIS 2 | EUV | EUV-2 | EUV-S | SS21 | BS4 | Latex 1xx - 3xx | Latex 5xx | Latex 7xx – 8xx |
Always carry out application tests on the original material.