Subli-Print® MDF Key Holder
Product number:
MDKH
Product information
Subli-Print® MDF Holder
The Subli-Print® MDF Holder has a print area of approximately 126 x 254 mm and is supplied with 4 hooks to be mounted after printing.
The key holder is made of a strong 12,7 mm thick MDF board and has two mounting points on the back. The print area is protected by a protective film which must be removed before printing.
Instructions
The following information is intended as a guide and may vary due to tolerances (material properties, sublimation inks and paper, substrate and ambient temperature, etc.). We recommend storing the items to be sublimated at room temperature for at least 24 hours before processing.
| Mirror subject | Yes |
|---|---|
| Pressing temperature | 190 °C |
| Pressing time | 160 seconds |
| Contact pressure | Low, 1,5 - 2,5 Bar |
Always carry out application tests on the original material.